Specification for filling carbon dioxide cylinders
Carbon dioxide at room temperature and pressure is a colorless, odorless (smell no taste) and slightly sour gas, carbon dioxide has industrial carbon dioxide and food carbon dioxide, the following introduction to carbon dioxide cylinder filling specifications:
1. Keep the indoor concentration alarm in good condition,if alarm go off, stop filling immediately and cut off the inlet valve.
2. Calculate the filling weight of liquid carbon dioxide. When the Weigh beam reaches the middle position of the caliper and the carbon dioxide filling meets the requirements, the discharge valve of the carbon dioxide tank and the pressure valve of the carbon dioxide cryogenic dewar tank should be closed immediately.
3. Liquid carbon dioxide filling was carried out by carbon dioxide cryogenic pump
4. Check the value of pressure gauge and the operation of exhaust fan frequently during filling.
5. Put the gas cylinder on the filling scale, connect the filling nozzle, and start the switch for filling.
6. When vacuuming, first check whether the pipes in each part are blocked and whether the vacuum gauge is normal. If there is any abnormal phenomenon, remove it before vacuuming. All vacuum cylinder, must tighten the valve, so as not to breathe air into the cylinder again. If the valve leaks or is not tightened, the vacuum should be pumped again.
7. After carbon dioxide filling is completed, the relevant pump shall be informed to stop immediately and the liquid in the cylinder shall be mixed evenly.
8. Before filling carbon dioxide cylinders in the irrigation area, the manufacturer's certificate of delivery must be obtained, and no obvious defects can be observed before filling. New cylinders or unused cylinders after maintenance must be vacuumed.
9. Carbon dioxide valve leak detection.
10. After carbon dioxide filling, the scale shall not store the gas cylinder for a long time, and no accumulation is allowed in the filling scale. The heavy cylinders after filling are placed neatly according to the specified position .






